These Precision Flush Cutter Pliers leave a flat, flush cut instead
of the sharp little nub most pliers leave behind on a trimmed wire or lead.
The narrow, tapered jaws get into tight component clusters or right up against a
connector without the bulk of standard side cutters getting in the way. Spring-loaded
handles pop the jaws back open automatically after every cut, so there's no manual
resetting between snips on a long job. Rated for copper wire up to 1mm (.040") in
diameter, with comfort-molded handles that keep your hand from cramping after
repeated use.
Best Uses
Trimming component leads and copper wire close to the board
Cutting zip ties flush so there's no sharp tail left behind
Snipping small-gauge wire, jumper leads, and thin cable
General electronics, hobby, and craft work where a clean, flat cut matters
Why Flush Cutters Beat Standard Side Cutters
Regular side cutters have a beveled edge on both sides of the blade, which leaves a
small pointed stub on whatever you cut. Flush cutters are ground flat on one side,
so the cut comes out level with the surface — no sharp edge, no extra trimming
pass needed.
Specs
Model: 170
Jaw type: Flush-cut, tapered tip
Cutting capacity: Up to 1mm (.040") copper wire
Handle: Spring-loaded, comfort-molded grip
Best for: Electronics leads, copper wire, zip ties, fine wire work
Note: Use safety glasses when cutting — small offcuts can fly
